घर आर सी खिलौने Eachine Wizard X220S Upgraded FPV Racer Drone Flight Test Review

Eachine Wizard X220S Upgraded FPV Racer Drone Flight Test Review

साइट बनाना चाहते हैं? ढूँढें नि: शुल्क WordPress थीम्स और plugins.

This modification to the Wizard X220 includes lots of upgrades including improved FCB, ESC's, camera, FPV transmitter, FOUR battery, and props. Discover that right here

Lots of enhancements have actually been actually included over the initial X220 Wizard. Details feature:
Omnibus F4SD air travel management panel with Betaflight 3.1.7
– 2206/2300 KV motors.
– 30 Amp 4in1 Dshot 600 ESC's.
Higher settlement 800 TVL FPV cam.
– 72 network 25/200/600mW FPV transmitter.
FPV on display screen display (OSD).
FOUR 14.8 V 1500mah electric battery.
Pagoda II highly omni-directional FPV transmitter aerial.
– 5501 higher pitch tri-blade props (features 5 total sets).

Some increasing discomforts along with the early release. Most of the complying with are actually minor issues, however perhaps they could be repaired for future production runs.
Ready to pilot model includes Flysky duplicate transmitter. You will certainly need to configure the transmitter to set aux shifts off the switching handles to actual buttons, aloong along with establishing failsafe control.
Arms are actually fiberglass/composite. Some have stated them breaking in an accident or hard landing. Banggood is apparently sending substitute complex arms to improve this problem.
All the electric motor accessory screws on my quadcopter hung. Be sure to check and tighten all screws just before your initial tour.
Camera managements are all concealed under the electric battery straps. Inconceivable to gain access to without removing the strap or top board from the quadcopter.
Video camera was way out from concentration away from package. Yet its own conveniently concentrated through merely turning the lens after loosening up the external padlock ring. Perform such while using your goggles to check the concentration.
VBAT is off by default in Betaflight. You'll should transform that on if you wish OSD current show.
Provided wrenches are certainly not the appropriate dimension for the prop hair almonds.
Micro USB port is "concealed" along with a rubber defense cover. Seek this simply to the right from the microSD card slot.

Affiliate links: At no cost to you, I do get a little percentage offer for sale resulting from these links.

This video recording along with every video recording of the Quadcopter 101 stations was created as well as revised with VSDC Free Video recording Editor. You could download this outstanding, and also no joking "cost-free" online video editor listed below.

" Awel" by stefsax.

is authorizeded under an Artistic Commons license:.

popular music was reduced to match length from video recording.

आप android के लिए apk मिला? आप नया पा सकते हैं नि: शुल्क Android खेल और क्षुधा.


  1. New to FPV racing quads. Just got a 250 FPV racer used off of eBay with a GoolRC controller. Really like you doing a review on this racer. My racer has a KK2.1.5 mini FC board and SimonK 12A ESC’s with AKASO D2204 – 2300kv brushless motors. I just order FPV transmitter and camera to install. It is quite different than flying a SYMA or a PROMARK quad!!! I just ordered Eachine EV800 goggles as well. Thanks for sharing your videos! Juddie

  2. दुर्भाग्य से, it seems to be more common these days to receive one of these racers with the camera out of adjustment. I had an Eachine QX95 with an out of focus cam, as well as a KingKong90GT. As you say, its easy to fix, but its even easier for the manufacturer to take the time to check to see if its IN focus before leaving the plant. The video seemed much better with the regular RHCP antenna on it vs. the Pagoda .. which was giving a lot of dropouts. Maybe it was defective? Unusual for the craft to just drop out of the sky like that, unless it was a de-sync problem with the FC board (perhaps pushing the frequency on the CPU too hard .. check to see what the CPU load is in Betaflight .. if its over 25-30%, that could be a problem. I try to run mine at 15% load or less. As for the lines in the FPV video, that looked like noise on the DC power line to the camera .. not enough filtering. Some guys have fixed that kind of problem by installing one of those cheap/small Puolu DC-DC converters somewhere on the craft, and powering the camera with it, since it produces nice clean power. Well, at least you didn’t hit your car when it dove in (or anyone else) .. that’s a plus. Thanks for the review. Cheers.

आपकी टिप्पणी छोड़ दो

आपका ईमेल पता प्रकाशित नहीं किया जाएगा. आवश्यक क्षेत्रः चिह्नित कर रहे हैं *